Show link_ioctls.h syntax highlighted
/*
*
* Copyright (c) 2003 The Regents of the University of California. All
* rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
*
* - Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
*
* - Neither the name of the University nor the names of its
* contributors may be used to endorse or promote products derived
* from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS''
* AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO,
* THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
* PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR
* CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL,
* EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO,
* PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR
* PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY
* OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
* OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*
*/
#ifndef __LINK_IOCTLS_H__
#define __LINK_IOCTLS_H__
/* ioctl numbers for commands on a link */
#define LINK_IOCTL_TYPE 0x8c
enum {
LINK_PROMISC_MODE_NONE=0, /* not promisc */
LINK_PROMISC_MODE_ACTIVE, /* cause lower layer to become promisc */
LINK_PROMISC_MODE_PASSIVE, /* just passively receive all traffic */
LINK_PROMISC_MODE_MAX
};
// sets promiscuous listening of a link connection
#define LINK_SET_PROMISC _IOW(LINK_IOCTL_TYPE, 0x4, int)
/*****************************************************
***
*** NOTE: ioctl() is deprecated as a means of
*** configuring links. Please use and extent the
*** link command/status facility instead, for any
*** device-wide configuration mechanisms.
***
*** (Note: PROMISC will stay in ioctl() form because
*** it is necessarily per-connection)
***
*****************************************************/
// ioctl to get a link status struct out for the link
#define LINK_GET_STATUS _IOR(LINK_IOCTL_TYPE, 0x0, link_status_t)
// Resets the link device
#define LINK_RESET _IO(LINK_IOCTL_TYPE, 0x1)
// set interface id, for interfaces where it is supported
#define LINK_SET_IFID _IOW(LINK_IOCTL_TYPE, 0x2, if_id_t)
// sets the On/Off state for the radio -- 1 for on, 0 for off
#define LINK_SET_ACTIVE _IOW(LINK_IOCTL_TYPE, 0x3, int)
// sets the POT value for the radio, if supported
#define LINK_SET_POT _IOW(LINK_IOCTL_TYPE, 0x5, int)
// Sets TX power mode. Used in berkeley mac for low power operation
#define LINK_SET_TXMODE _IOW(LINK_IOCTL_TYPE, 0x6, int)
// Sets LISTEN power mode. Used in berkeley mac for low power operation
#define LINK_SET_LSMODE _IOW(LINK_IOCTL_TYPE, 0x7, int)
/*****************************************************
***
*** NOTE: ioctl() is deprecated as a means of
*** configuring links. Please use and extent the
*** link command/status facility instead, for any
*** device-wide configuration mechanisms.
***
*** (Note: PROMISC will stay in ioctl() form because
*** it is per-connection)
***
*****************************************************/
#endif
See more files for this project here
EmStar is a software system for developing and deploying wireless sensor networks involving Linux-based platforms. As the wireless sensor network community has attempted to deploy more complex designs---large-scale, long-lived systems that need self-organization and adaptivity---a number of difficult software design issues have arisen. Advances in software design have not kept pace with the capabilities of hardware. This is because designing for an adaptive, efficient, and useful sensor network has turned out to be surprisingly complex and difficult. EmStar is a Linux-based software framework, whose goal is to dramatically reduce this complexity, enabling work to be shared and reused, and simplifying and speeding the design of new sensor network applications.
Project homepage:
http://cvs.cens.ucla.edu/emstar/
Programming language(s): C,Shell Script
License: other
conntest.h
connview.h
libmacinfo.h
link.h
link.run
link_headers.h
link_ioctls.h
link_multi.h
link_parse.h
link_pass.h
link_structs.h
linkstats.h
lqe.h
neighbor.h
neighbor_structs.h